58
EN
the switch is turned counter-clockwise, speed will be reduced gradually. If the speed falls
below minimum level, the appliance will automatically enter to “Stand-By” mode.
Dust container indicator light
This light turns on in white when the appliance starts operation and turns to red when cyclone
lter and / or two ply motor protection lter is clogged.
H.E.P.A. Filter indicator light
This light turns on in white when the appliance starts operation and turns to red when H.E.P.A.
lter needs to be replaced or air discharge region is clogged.
ESF indicator light
This light turns on in white when the appliance starts operation. And red if ESF lter is not
installed.
Warning: The appliance operates without ESF lter installation, but we recommend to use
the appliance installing all the lters to achieve full ltering performance.
ION indicator light
This light turns on in white when the appliance starts operation. The appliance is designed to
operate with active ION feature during rst time usage. You can activate or de-activate ION
feature by pressing speed adjustment switch once.
Cord rewind button
Press the cord rewind button for rewinding the cord automatically. Apart from cord rewind
button, the cord will automatically rewind by pull / push cord rewind system. To do this, it
would be enough to pull and release the cord from a suitable location.
Floor type indicators
Displays oor type range according to speed adjustment level. Especially when using with the
controller, you can switch between different oor types according to previously determined
adjustment levels.
After operation
WARNING!
Immediately after completing your vacuuming, perform the steps below. Never leave your
appliance unattended.
To Next Page
Loading...
