Pan Support – 5kg
Stainless Steel Surfaces
These should be cleaned with hot water and detergent then dried and polished with a soft cloth.
Cleaning agents containing bleach, abrasives or caustic chemicals will damage or stain such a surface and must
never be used.
Vitreous Enamel Surfaces
Approved cleaning agents which have the mark of the Vitreous Enamel Development Centre are recommended.
It is advisable to clean daily after use. Wipe clean the vitreous enamel surfaces while still warm, but not hot
enough to cause burns, using a soft cloth and hot soapy water. Badly stained removable parts should be soaked in
hot water with an approved detergent. If parts cannot be removed, the application of warm water with an
approved detergent using nylon or scotch-cleaning pads will give good results.Oven
Oven shelves may be removed for cleaning by lifting stops over front side of runners, but the enamelled linings
are not removable, except for servicing. Daily cleaning is best, preferably while the oven is still warm, but not hot
enough to cause burns. Use of a proprietary detergent is the best general method. For stubborn deposits a
proprietary oven cleaner may be used in accordance with the manufacturers' instructions. Before removing any
part for cleaning, note how it is arranged and ensure that it is replaced correctly.
Open Top (G2102 C only)
Pan Supports
Clean with warm soapy water. Abrasives such as fine steel wool, proprietary cleaning pads or nylon pan
scrubbers, should be used with care and only in cases of extreme overspill. Dry off the pan supports by hand.
NEVER LEAVE TO DRY NATURALLY.
After drying, apply a light film of vegetable oil. This will prevent oxidisation.
CLEANING INSTRUCTIONS for OPEN TOP BURNERS
The following instructions should be followed when:
a) A spillage has occurred on the burner.
b) The burner fails to light or remain lit.
c) At the end of each day or cooking period.
Caution
Parts may be hot therefore it is recommended that parts be allowed to cool to a safe
handling temperature to avoid burns.
1. Remove pan support.
2. Remove burner head and bezel by lifting upward.
3. Thoroughly clean with soap and water. Ensure all burner ports are clean and free from food or cleaning
material debris.
To Next Page
Loading...
Need help?
General
