Falcon G2844F - Page 6

6
2.4.1 G2844F Fryer Control Panel
(See Figure 2)
1
2 5 3
4
Figure 2 – G2844F Control Panel
1) Four Digit LED Display
Displays Set temp, Actual temp, cook time remaining and also used for programming purposes.
2) Program Button
Used to enter timer program mode (to change each of the 4 pre-set timer select channels - See Section 6).
3) Temperature Button
Used to view actual/Set temperature and also to enter Set temperature mode (See Section 6).
4) Timer Keys (1 – 4)
Used to start/cancel pre set cook times. Buttons 1 & 4 also used to change times or temperatures when in
either set mode (See Section 6).
5) Heat demand LED indicator
This indicator will illuminate when thermostat demands heat, i.e. oil is more than 2⁰C below the programmed set
temperature.
The indicator will extinguish when desired setting is reached.
2.4.2 G2845F Fryer Control Panel
(See Figure 3).
3
2
4
1 5
Figure 3 – G2845F Control Panel
1. ON/OFF and Temperature Control Knob
Temperature Selection (140 - 190°C).
(Unit is off when in position indicated).
2. Fat Melt Position
Feature for slow pulsed heating of solid fats.
3. Power on indicator.