Need help?Do you have a question about the Falcon GSM and is the answer not in the manual?
General| Brand | Falcon |
|---|---|
| Model | GSM |
| Category | Transmitter |
| Language | English |
Options for single/dual SIM and GPRS reporting to control room.
Covers inputs, AC monitoring, relay outputs, Contact ID, serial interfaces, and OTR panel uploading/downloading.
Details full programming and software updates via serial port and over-the-air GPRS.
Explains status/error indication via seven-segment display and serial port selection via pushbutton.
Provides connection diagrams and explanations for the Falcon GSM unit.
Connects Falcon GSM to stable 12V DC power supply, preferably from alarm panel battery.
Explains AC input for detecting power failure and connecting to transformer secondary terminals.
Uses dry contact inputs for alarms from panels/other sources; includes pull-up jumper use.
Intercepts alarm signals via telephone line (Contact ID) interface; requires panel programming.
Lists compatible alarm panels for receiving alarms via the Falcon GSM's serial port.
Details two dry-contact relay outputs (24V AC/DC, 5A) controllable via GSM network.
Covers initial power-up and display of software/hardware versions on the Falcon GSM.
Discusses GSM network quality and strong signal importance for reliable alarm transmission.
Explains changing default SIM card to one with highest signal strength for better connectivity.
Selects alarm panel serial port formats via onboard push-button or PC software.
Details the seven-segment display for operating status and error codes.
Uses onboard push-button to change serial port operation, referencing Section 3.4.
Uses Windows-based configuration software via a PC serial port for programming.
Illustrates Falcon GSM serial interface cable wiring and specifications.
Sets serial port format to Texecom and connects to Texecom alarm panels.
Sets serial port format to Paradox and connects to Paradox alarm panels.
Sets serial port format to Pima and connects to Pima alarm panels.
Connects Falcon GSM to DSC PowerSeries Neo panels via PC LINK_2 header.
Connects Falcon GSM to DSC PowerSeries via keypad-bus and FSK Key-bus Module.
Connects Falcon GSM to IDS805 via keypad-bus and FSK Key-bus Module.
Sets serial port format to IDS and connects to IDS X-Series panels.
Connects Falcon GSM to Risco LightSYS 2 via RS232 COM port.
Connects Falcon GSM to Orisec panels via serial cable; warns about wrong connections.
Installs drivers for the FSK USB to UART Programmer before connecting.
Installs Falcon GSM configuration software from the FSK DVD.
Shows software interface and initial steps for connecting and reading device settings.
Illustrates completed software settings with unchangeable options.
Configures input and output settings within the Falcon GSM configuration software.
To Next Page
