Ÿ IDS805 FSK Key-Bus
Ÿ Risco LightSYS 2
Ÿ Orisec
Refer to Appendix A
To change the serial port format:
Ÿ Remove the power from the Falcon GSM
Ÿ Hold down the push-button and re-apply the power
Ÿ Release the button then push the button to cycle through the
panel serial port settings until the correct serial port is
displayed
Ÿ Leave the button for 15 seconds. The will Falcon GSM
remember the new serial port format
See table on next page.
GSM
Falcon GSM Installation and Operation Manual I
13
To Next Page
Loading...
