FALEEMI FSC776 - Step 2: Scan Camera QR Code

09
10
6. Click on [The blue light is flashing
slowly].
8. Input your WiFi password and click on
[Connect to WiFi].
7. Type in the name you have selected for your
camera and click on [Next].
if you can't scan the QR code, please enter the
if you can't scan the QR code, please enter the
DID (something like
DID (something like
VIEW-1234567-ABCDE
VIEW-1234567-ABCDE)
in the label on the camera manually.
in the label on the camera manually.
Please use the default username of
Please use the default username of
admin
admin
and password of
and password of
123456
123456
here.
here.
You can change them when the camera is all set up.
You can change them when the camera is all set up.
You will find the instructions in
You will find the instructions in
Page 26.
Page 26.
Click on it to make sure your
Click on it to make sure your
WiFi password is correct.
Setup Option B
Setup Option B
123456
9. It generates a QRcode on your phone.
Bring this QR code within 6 inches of the
camera (looking at the lens of the camera)
and keep it still. When you see blue light will
blink very rapidly, it is done.
The blue light will
blink very rapidly
≈15cm(6 in)
Model: FSC776B/W
Quick Start Guide
HD Pan/Tilt Wireless Network Camera