FALEX 430 ETR - Warning Messages; Error Messages

5: Maintenance /Service
45
Warning Messages
[ This is not a complete list, these are commonly encountered Warning Messages, for any other Warning Messages
please contact your Falex Representative or Compass Service ]
Message
Condition
Effect
Comments
Device not calibrated.
Please Calibrate!
The file ‘CalibrationData.cal’
doesn’t exist in the HMI folder.
No measurement can
be started.
Contact Falex Rep/Compass
Service
No Camera Settings File
Found!
The file ‘CameraSettings.param’
wasn’t found in the HMI folder.
No standard settings
for the camera can
be loaded in the
Camera Settings
Screen
Contact Falex Rep/Compass
Service
No Parameter File
Found!
The file ‘DeviceParameters.param’
wasn’t found in the HMI folder.
Device parameters
can’t be reset to
standard settings.
Contact Falex Rep/Compass
Service
Error Messages
[ This is not a complete list, these are commonly encountered Error Messages, for any other Error Messages please
contact your Falex Representative or Compass Service ]
Message
Condition
Effect
Comments
Shutter Not Closed
Shutter is not closed. Left Limit
Switch is not triggered.
No measurement can
be started.
Refer to Section 3.5.7 ‘Shutter’
Or Contact Falex Rep/Compass
Service
Init aborted. Please
Restart the device.
Initialization was aborted when
HMI was loaded.
Device can be used as
Normal, but it is
Recommended to
Restart the device to
Restart the
Initialization.
Refer to Section 3.5.7
‘Start Initialization’ or
Contact Falex Rep/Compass
Service