FANATEC CSL Elite Wheel Base + User Manual

12
5.3 Hard-mounting the CSL Elite Wheel Base+
The CSL Elite Wheel Base+ offers a three-point hard-mount location on the
bottom side of the CSL Elite Wheel Base (see the right hand side picture
below.) To hard-mount the wheel base, rst disassemble the two blocks from
the bottom side with a 3mm Allen key (not included), see highlighted on the left
hand picture below:
IMPORTANT: Use only good quality M6 screws. Choose the screw
length so that the thread does not reach more than 16 mm into the wheel
base. Example: If your table thickness is 20 mm the screw must not ex-
ceed a total thread length of 36 mm! Always use all three hard-mount
points, this allows a proper and stable installation and avoids damage!
Table
max 16mm
X
To hard-mount the CSL Elite Wheel Base+ to a table or rig by screws please
nd the printable drilling template in the download area of our website
www.fanatec.com.

FANATEC CSL Elite Wheel Base + Specifications

General

Brand	FANATEC
Model	CSL Elite Wheel Base +
Category	Video Gaming Accessories
Language	English