HOUSE SETUP tab page Outside
Measurement outside
temp.
Setting indicating if outside temperature measurement is used. If outside temperature
measurement is used the outside temperature can influence a number of controls.
Setting indicating if outside RH measurement is used. Using absolute moisture
calculation, the control computer determines if the outside air is suitable for
dehumidification.
Setting indicating if wind direction and wind speed measurement is used. If wind
direction and wind speed measurement is used the wind can influence a number of
controls.
HOUSE SETUP tab page Combi
Setting indicating if the controllable part of the ventilation control consists of linear
controllable fans (LINEAIR), or linear controllable fans with extra fans (LINEAR+E). or
modulating on/off fans (RELAY).
Setting indicating the number of analog (linear controllable) groups that you want to
activate as extra fans in the controllable part (only if LINEAR / LINEAR+E has been
chosen at Power-part).
Setting indicating the number of groups, switched by a relay that you want to activate as
extra fans in the controllable part (only if LINEAR / LINEAR+E has been chosen at
Power-part).
Setting indicating if vortex damper control is used. A vortex damper is always controlled
analog. There is one vortex damper control per extra switched fan. (only if
LINEAR/LINEAR+E has been chosen at Power-part)
To Next Page
Loading...
General