Setting indicating which ventilation system is used in the house: –N–, –NP, –NT, PNT,
PN-, PNP or others (P=Power, N=Natural, T=Tunnel, ‘–’=Not Used).
Setting indicating which type of ventilation is used in the house: CROSS, STAIR,
RIDGE or LENGTH.
Setting indicating the number of air inlets to be used.
Setting indicating the number of tunnel inlets to be used.
Setting indicating the number of natural air inlets to be used.
Setting indicating the number of stages to be used in the combi-table.
Setting indicating the number of stages to be used in the combi-table.
Setting indicating the number of relays you want to use for the extra fans.
HOUSE SETUP tab page Clocks
Setting indicating if registration inputs are used.
Setting indicating if clocks are used.
Setting indicating if light clocks are used.
Setting indicating if light relays are used.
Setting indicating if light control is used.
Setting indicating if light measurement in the house is used.
Setting indicating if feed clocks are used.
Setting indicating if feed registration is used.
Setting indicating if the amount of water must be registered. A connected water meter is
required. Enter the water meter data at registration.
Setting indicating if water registration is used.
Setting indicating if extra clocks are used.