Fancom LUMINA 16 - Page 46

Lumina 16
Installer
42
INSTALLER  HEATING
Description
Setting of the name of the function.
Temp. inputs
Setting the addresses of the analog inputs. If the temperature sensors have not been
assigned, the control computer will use the house temperature.
Control
Setting of the heating control type: LINEAR or RELAY.
Output address
Setting of the analog output address (choice LINEAR) or relay output address (choice
RELAY).
Relay type
Setting of the type of relay control. ON/OFF or MODULATING.
Analog type
*
Setting indicating the analog control type
Precontrol
Setting indicating if the heat demand should be transmitted to a central boiler control
(precontrol).
INSTALLER  HUMIDIFICATION
Description
Setting of the name of the function.
Output address
Setting for the analog output address (choice LINEAR) or relay output (choice RELAY).