Setting of the type of relay control. ON/OFF or MODULATING.
Setting of the name of the function.
Setting the addresses of the analog inputs. If the temperature sensors have not been
assigned, the control computer will use the house temperature.
Setting of the heating control type: LINEAR or RELAY.
Setting for the analog output address (choice LINEAR) or relay output (choice RELAY).
Setting of the type of relay control. ON/OFF or MODULATING.
Setting indicating if evaporative cooling is used (YES or NO).
Setting of the time the cooling is active.
Setting of the minimum / maximum on time of the cooling.
Setting of the time after which the same clock controls must be repeated.
To Next Page
Loading...
General