FG7X Housing Instruction Manual 20150101
the anti-glare hood over the top rail (image #3) and then gently and carefully stretch it
downwards to install it on the bottom rail, making sure it’s sitting securely on both upper
and lower rails (image #4).
e. If using a Hand Strap, install it on the two loops found at the right side of the housing.
Please refer to the section “Hand Strap” for further information.
f. It is important that a first dive with the housing is always made without the camera in
order to verify that the housing watertight seal has not been affected during transport
and after long periods of storage.
To Next Page
Loading...