FG7X Housing Instruction Manual 20150101
5. Slide the alarm unit back into the dedicated slot inside the housing, opposite the buckle. Make
sure to install the alarm unit with the round alarm cylinder facing the housing interior and the
LED pointing outwards, to the back of the housing (image #32 on the previous page).
6. You can test the Moisture Detector by placing a wet finger over the moisture sensor unit at the
bottom of the housing. Once you have confirmed that the alarm is working, gently dry off the
moisture sensor unit. This should silence the alarm.
For further information, please visit our website
www.fantasea.com or contact us at info@fantasea.com
To Next Page
Loading...