5.SETTING UP CIMPLICITY HMI OPERATION B-82604EN/01
- 18 -
CAUTION
CIMPLICITY version 4.01 can connect to robot
controller control unit with the model type both GE
Fanuc Series 90-30 and 90-70, but CIMPLICITY
version 5.5 can connect with the model type
GE-FANUC Series 90-30 only.
In the case that you update CIMPLICITY to version
5.5 or later, your project that uses GE-FANUC
Series 90-70 may not work. Please change the
device type from GE-Fanuc Series 90-70 to 90-30.
Select the TCP/IP tab, and set the IP address of R-J3 set on the host
communication setup screen.
Check Enable.
Clicking OK registers S90_DEV1 as Device.
To Next Page
Loading...