ENGLISH
GB-10
Incorrect installation may cause vibrations and
noise and may cause the machine to move about.
To do these when the machine is not level:
• Using the spanner turn locknut in a clockwise
direction. en turn locknuts together with
adjust feet to unscrew.
• Hold adjust feet securely with a pipe wrench.
• Turn locknut again using the spanner until it
sits rmly up against the housing.
Note
Vibration and noise may occur if the
locknuts do not sit rmly up against
the houses.
Drain hose connection
1. Direct into a sink
If the outlet spigot has not been used before,
remove any blanking plug that may be in
place.
Push the drain hose onto the spigot and
secure with a clip if required, ensure a loop
is formed in the drain hose to prevent waste
from the sink entering the washing machine.
To Next Page
Loading...