ENGLISH
GB-11
If required, the drain hose can be extended to
a length of 4 m.
Loop
2. Connected securely to a standpipe
Firstly form a hook in the end of the drain
hose using the “U” piece supplied.
Place the drain hose into your standpipe,
which should have an internal diameter of
approximately 30mm thus ensuring there
is an air break between the drain hose and
standpipe.
When discharging into a standpipe ensure
that the top of the standpipe is no more than
90cm and no less than 60cm above oor
level.
“U” piece supplied
To Next Page
Loading...