ENGLISH
GB-12
Water inlet connection
Connect the inlet hose supplied with the
machine to a tap with a 3/4” thread.
Do not use previously employed hoses.
Installation should comply with local water
authority and building regulations’ requirements.
When there is a inlet valve at the back of the
machine, it must be connected to a cold water
supply. If there are two inlet valve, one is
connected to a cold water supply and the other
is connected to a hot water supply. Follow the
indication of the picture below to complete the
connection.
inlet valve for cold water
inlet hose for cold water
with a white nut
To Next Page
Loading...