ENGLISH
GB-31
Rotate the adjusting screw to drive the adjustor
to strain or relax the steel cable.
2. Door spring tension is correct when the
door remains horizontal in the fully opened
position, yet rises to a close with the slight
lift of a nger.
Step 4. Dishwasher installation steps
Please refer to the specied installation steps
in the installation drawings.
1. Ax the condensation strip under the
work surface of cabinet. Please ensure the
condensation strip is ush with edge of work
surface. (Step 2)
2. Connect the inlet hose to the cold-water
supply.
3. Connect the drain hose.
4. Connect the power cord.
5. Place the dishwasher into position. (Step 4)
6. Level the dishwasher. e rear foot can be
adjusted from the front of the dishwasher by
turning the Philips screw in the middle of
the base of dishwasher use a Philips screw.
To adjust the front feet, use a at screwdriver
To Next Page
Loading...
