What to do if coulters float out of the ground during field operation of Farm King 1460 Farm Equipment?
First, ensure that the Work Circuit is in detent during the entire work cycle. If the issue persists, the reducing/relieving valve pressure might not be set high enough for the soil conditions. Adjust the valve pressure upwards in 100 psi increments until gauge wheels maintain constant contact with the ground.
What to do if my Farm King 1460 toolbar does not stop before wings achieve the unfolded, level position during transport unfold?
Check to ensure all electrical connections are good, as there may be no power to the microswitch, meaning solenoid valve (2) is not enabled. Also, the microswitch position may need adjustment to enable solenoid valves at the correct height. If the issue persists, the solenoid valve (2) may not be functioning properly and might need to be checked or replaced.
What to do if the wings of my Farm King 1460 Farm Equipment do not stop slightly above level when lifting the toolbar for end row turns during field operation?
Check to ensure all electrical connections are good, as there may be no power to the microswitch, meaning solenoid valve (1) is not enabled. Also, the microswitch position may need adjustment to enable solenoid valves at the correct height. If the issue persists, the solenoid valve (2) may not be functioning properly and might need to be checked or replaced.
Why do outer wings drift back during field operation of Farm King 1460 Farm Equipment?
The tractor hydraulic valve may not be placed into detent. Make sure that the Work Circuit is in detent during the field operation.
What to do if my Farm King 1460 Farm Equipment chatters or bounces during transport unfold?
The tractor oil flow through the transport circuit valve may be set too high. Reduce the tractor flow rate until the chatter or bounce stops, aiming for 4 to 6 GPM.
What to do if my Farm King Farm Equipment wings do not raise or lower evenly?
The flow divider may not be functioning properly. Check it and replace it if necessary.
What to do if my Farm King 1460 toolbar does not move from the folded position during transport unfold?
The reducing/relieving valve pressure may be set beneath the pressure needed to extend the mid-wing. Increase the valve setting by turning the set screw clockwise by quarter turns until the toolbar unfolds.
What causes the center cylinder of Farm King 1460 to chatter or not lower when lowering the toolbar to field operation position?
This issue may occur due to a few reasons: 1. The counter balance valve might be cycling in rapid succession due to insufficient oil flow. Increase the oil flow from the tractor SCV. 2. The counter balance valves may be out of adjustment. Increase the tractor engine rpm to increase hydraulic oil flow. 3. The counter balance valve may be defective and needs replacement.
What to do if the outer coulters run too deep or the center section runs too shallow on my Farm King Farm Equipment?
Change the depth control stops on the center cylinders. Also, reset the wing gauge wheel height.
Why do the wings of my Farm King 1460 Farm Equipment drift oppositely when horizontal and the directional valves are not being used?
The pilot operated check valves may not be operating properly. Check them and replace if necessary.
Guidelines for safe operation and operator qualifications.
Procedures and precautions to prevent fires during operation and maintenance.
Explains the meaning and location of safety decals on the equipment.
Pre-operation checks, break-in procedures, and tractor requirements.
Detailed steps for operating the applicator in the field.
Common problems, causes, and solutions for the applicator.
General| Brand | Farm King |
|---|---|
| Model | 1460 |
| Category | Farm Equipment |
| Language | English |
To Next Page