Maintenance - RT17, RT19 Tedder
43
Storage And Return To Service
Storage
Sometimes it may be necessary to store the
equipment for an extended period of time. Below
is a list of items to perform before storage.
IMPORTANT
DO NOT permit children to play on or around
the stored machine.
• Thoroughly wash the machine with a pressure
washer or water hose to remove all dirt, mud, debris
or residue.
• Lubricate all bushings to remove any water residue
from washing.
• Remove any material that has become entangled
around any moving part.
• Place hydraulic hoses or electrical connector (if
applicable) in the storage brackets.
• Inspect the hitch and all welds on the equipment for
wear and damage.
• Check for loose hardware, missing guards, tines, or
damaged parts.
• Check for damaged or missing safety signs (decals).
Replace if necessary.
• Replace worn or damaged parts.
• Touch up all paint nicks and scratches to prevent
rusting.
• Place the equipment in a dry protected shelter.
Note: If a dry protected shelter is not available,
cover with a waterproof tarp and tie down
securely.
• Place the equipment flat on the ground.
• Support the jack / frame with planks if required.
Return To Service
After the equipment has been in storage, it is
necessary to follow a list of items to return the
equipment to service.
• Be sure all shields and guards are in place.
• Lubricate the equipment.
• Connect to a tractor and operate equipment, verify
all functions operate correctly.
• Repair as needed.
To Next Page
Loading...