Maintenance - RT17, RT19 Tedder
42
Safety Sign (Decal) Installation
IMPORTANT
When replacing safety signs (decals), the
temperature must be above 10° C (50° F).
• Remove all portions of the damaged safety sign
(decal).
• Thoroughly clean the area with adhesive remover
and glass cleaner. Remove all adhesive residue.
• Allow the area to dry completely before installing the
new safety sign (decal).
• Position the safety sign (decal) in the correct location.
• Remove a small portion of the backing paper on the
safety sign (decal).
• Press on the safety sign (decal) where the backing
paper has been removed.
• Slowly remove the remaining backing paper,
pressing on the safety sign (decal) as the backing
paper is removed.
• Using the backing paper, pressing firmly, move the
backing paper over the entire safety sign (decal) area.
Note: Small air pockets can be pierced with a pin
and smoothed out using the piece of the
backing paper.
Tine Replacement
Periodically check all tines for wear or damage.
Figure 27
Replace the tines (Item 1) by removing the bolt,
nut, and retaining plate [Figure 27].
Slide the tine off of the arm (Item 2) [Figure 27].
Replace tine and attach with the bolt, nut, and
retaining plate.
2
1
To Next Page
Loading...