Faro Focus S Series - Pre-Compensation Setup; Site Setup Requirements; Connect Scanner via Wireless LAN

Supported Software • SCENE 7.0 or later
Supported Hardware
• FARO
®
Laser Scanner Focus
S
70
• FARO
®
Laser Scanner Focus
S
150
• FARO
®
Laser Scanner Focus
S
350
Preparation Before Compensation
Site setup
Before you begin the On-Site Compensation process, ensure that the scan site has the following facilities:
• Target sheets must be setup at the scan site at regular distance to the laser scanners between 1.5m to 3m.
• No windows or other reflective planes: The markers on the target sheets would be reflected if the scan site has any
windows or reflective surfaces. This can cause incorrect measurements.
• Lighting conditions are less important because On-Site Compensation is done with the laser, video images are not
used.
Connect Laser Scanner to Computer through Wireless LAN
To be able to transfer the scanned data directly to your computer, you must connect the computer with the laser scanner
and through WLAN to remotely access and control the scanner.
To connect to the scanner directly, follow this procedure.
1. Power on the scanner.
2. Navigate to Manage > General Settings > WLAN.
3. Toggle the Status button to the ON position.
4. Set the Mode to Access Point.
https://knowledge.faro.com/Hardware/3D_Scanners/Focus/On-Site_Compensation_Instructions_for_the_Focus_S_Series
Updated: Fri, 04 Sep 2020 19:09:50 GMT
2