www.fassride.com
(866) 769.3747
STEP 3 : PREPARE
SUCTION AND RETURN
LINES
E. Once you have marked the location of the suction bulk head (BHF-1002)
use a center punch and make a mark in the fuel tank. Then proceed to drill
a 1 3/8" hole, using a hole saw.
F. Now that the hole has been established, using a de-buring tool clean the edges of the
new hole to insure a quality sealing surface.(Note the fuel tank is steel and may have
sharp e
dges, gloves may be necessary.)
To Next Page
