www.fassride.com
(866) 769.3747
STEP 4:
MOUNT FUEL SYSTEM
H. With the FASS in place and all the hardware started, adjust and fit the system watching
for clearance to the truck frame and body. Once this is completed you can tighten all
hardware.
I. Now that the FASS is mounted and secure, remove the lowest bolt on the T bracket, install the 3/4"
cushion clamp (P/N#0790750) around the emergency brake cable and reinstall the bolt that was
removed. This is used to prevent damage to the FASS and the emergency brake cable.
To Next Page
