www.fassride.com
(866) 769.3747
STEP 6 :
REVIEW INSTALLATION
1. Blow out any open lines/cover any open ports
2. Bolts and fasteners properly tightened?
3. Electrical harness and fuel lines secured and properly tightened? Reconnect the battery.
4. Has the system been primed?
a. Turn key to the ignition position, turning on the FASS pump for 15 sec..
b. Crank engine and allow to run for at least 1 minute.
5. Check for leaks.
6. Start the engine
7. Recheck all fluid and filter connections for leaks
8. This pump comes with a 1 Year Manufacturer’s Warranty based on the date it has been
manufactured. To receive your extended Lifetime Warranty, you have 30 days from date of
purchase to send the completed warranty information
To assist with priming your FASS pump crack the XWS-3002. Put power to the FASS pump to
activate the pump. When the tone of the pump changes you can tighten up the fuel filter. If
you need a video of the priming process go to www.FASSride.com.
Note: The Red Plastic Plugs located in the “H” ports can stay in place fuel will not flow through
these ports. Coolant can be plumbed into these ports to heat the fuel in the Winter months.
To Next Page
Loading...
