The unauthorized use or duplica-
tion of the software described
herein, or this material, is strictly
prohibited.
229-51339 Rev A
© 2007 FAST
24/7 Tech Support:
1-800-243-9271
Operating Instructions
8
Product Counts
To Check Product Counts: press and hold the P key for
3 seconds. COUNTS will be displayed.
Press the P key. global will be displayed then the total
number of cook counts will be shown.
Press the P key. FILTRCNT will be displayed then your total
filter count will be shown.
Press the P key. DISPCNT will be displayed then your total
disposal count will be displayed.
Press the P key. TOTALX10 will be displayed then your total
x 10 global count will be shown. Then press the P key.
To Exit Product Counts: COUNTS will be displayed. Press
the up arrow key. EXIT will be displayed. Press the P key.
The controller will exit programming mode.
Force A Filter
To Force A Filter at any time of the day: press and hold
the SCAN and ENTER/EXIT FILTER keys at the same time
for 3 seconds. FILTER will be displayed and an alarm will
be heard.
Press the ENTER/EXIT FILTER key to start the filtering
sequence.
Operating the
Controller
CONTINUED
Filter / Polish
When filtering is performed, the oil must be dumped
from the vat for 3 minutes. The filter countdown will
then begin at 7 minutes, at which time the Polish
should be performed. At the end of polishing opera-
tion, the display will show FILL. Return the oil to the vat.
Press the ENTER/EXIT FILTER key to clear the message
and go into an idle state. The oil will be heated to the
correct pre-programmed temperature.
To Next Page
Loading...
Need help?
General
