To Next PageTo Next PageHow to troubleshoot no power on FASTRON. Controller?
If your FASTRON. Controller is not getting any power, there are several potential causes. First, check if the circuit breaker is off and reset it if necessary. Also, ensure that the controller is properly plugged into a power outlet. If neither of these solutions works, the 24VAC transformer may be defective and need replacement. In some cases, replacing the controller itself might be necessary.
What to do if my FASTRON. MERIDIAN displays 'PROBE'?
If your FASTRON. Controller displays 'PROBE,' it could indicate a defective temperature probe or that the probe is not properly connected. Try plugging in the probe securely. If the issue persists, the temperature probe may need to be replaced.
Why is my FASTRON. Controller not heating?
If the FASTRON. Controller is not heating, it could be due to a defective element, relay, contactor, or gas valve. In this case, replace the defective part. Alternatively, the controller itself might be defective, requiring replacement.
What causes FASTRON. MERIDIAN Controller to read the wrong temperature?
If your FASTRON. Controller is reading the wrong temperature, the temperature probe is likely defective and needs to be replaced.
General| Brand | FASTRON. |
|---|---|
| Model | MERIDIAN Series |
| Category | Controller |
| Language | English |
Defines operating temperature limits and cleaning procedures for the controller.
Lists programming codes and identifies controller components with labels.
Defines action alarms, appliance type, and energy saving features like manual setback.
Covers FAST.Flex timing, hold time linking, automatic hold display, and temp display.
Details filter lockout features, melt cycle, operating modes, and pressure valve settings.
Explains programmable stage temperatures and stage times.
Guides on starting/stopping cook cycles, responding to alarms, and holding timers.
Guides for operating the controller in Boil Mode and Fill Mode.
Details on checking product counts and understanding initial display codes.
Lists and describes various status codes displayed by the controller.
Steps to enter the product key programming mode.
Guides for programming code, recipe, name, time, temp, timing, and press settings.
Details on programming additional cook stages and action alarms.
Instructions for setting action alarm names and hold times.
Steps to enter system programming and set appliance type.
Configuring control type, tone volume, and temperature scale.
Setting setback time/temperature and filter count.
Configuring units for cook time and hold time.
Steps to enter offset programming and input offset temperature values.
Procedures for exiting offset programming.
Steps to enter library programming mode for product/alarm names.
Instructions for adding new names or modifying existing library entries.
Procedures for exiting library programming.
Identifies common problems, their causes, and solutions.
Lists part numbers for bezels, screws, and nuts.
A section for general notes and remarks.
