Basic Function Instruction
6 - 17
FUN 3
SKPE
SKIP END
FUN 3
SKPE
Symbol
Operand
N： SKIP END Loop number (N=0~127) N
can not be used repeatedly.
Description
● Every SKPE N must correspond to a SKP N instruction. They must always be used as a pair and you
should also make sure that the SKPE N instruction is behind the SKP N instruction.
●
SKPE instruction does not require an input control because the instruction itself forms a network which
other instructions can not connect to it. If the SKP N instruction has been executed then the skip operation
will be completed when the execution of the program reaches the SKPE N instruction. If SKP N instruction
has never been executed then the SKPE instruction will do nothing.
Example
● Please refer to the example and explanations for SKP N instruction.
Remark : SKP/SKPE instructions can be used by nesting or interleaving. The coding rules are the same as for
the MC/MCE instructions. Please refer to the section of MC/MCE instructions.
To Next Page
Loading...
