FATEK FBs-CB55 - Page 4

【Instruction】
Contents
Chapter 1: PLC Ladder Diagram and the Coding Rules of Mnemonic
1.1 The Operation Principle of Ladder Diagram
............................................................
1-1
1.1.1 Combination Logic
...............................................................................................
1-1
1.1.2 Sequential Logic
..................................................................................................
1-2
1.2 Differences Between the Conventional and PLC Ladder Diagram
..........................
1-3
1.3 Ladder Diagram Structure and Terminology
...........................................................
1-5
1.4 The Coding Rules of Mnemonic
..............................................................................
1-8
1.5 The De-Composition of a Network
............................................................................
1-11
1.6 Using Temporary Relays
........................................................................................
1-12
1.7 Program Simplification Techniques
........................................................................
1-13
Chapter 2: FBS-PLC Memory Allocation
2.1 FBS-PLC Memory Allocation
...................................................................................
2-1
2.2 Digital and Register Allocations
..............................................................................
2-2
2.3 Special Relay Details
..............................................................................................
2-3
2.4 Special Registers Details
........................................................................................
2-8
Chapter 3: FBS-PLC Instruction Lists
3.1 Sequential Instructions
...........................................................................................
3-1
3.2 Function Instructions
..............................................................................................
3-2
Chapter 4: Sequential Instructions
4.1 Valid range of the Operand of Sequential Instructions
............................................
4-1
4.2 Element Description
...............................................................................................
4-2
4.2.1 Characteristics of A, B, TU and TD Contacts
...........................................................
4-2
4.2.2 OPEN and SHORT Contact
...................................................................................
4-3
4.2.3 Output Coil and Inverse Output Coil
........................................................................
4-4
4.2.4 Retentive Output Coil
............................................................................................
4-4
4.2.5 Set Coil and Reset Coil
.........................................................................................
4-5
4.3 Node Operation Instructions
...................................................................................
4-5