Need help?Do you have a question about the FCI FS10i and is the answer not in the manual?
Details the materials compatible with the FS10 sensor for various process media.
Describes the available process connection options for FS10A and FS10i models.
Specifies the flow sensitivity and operational range for air/gas and liquid media.
Outlines the instrument's repeatability and temperature-related performance variations.
Lists various agency approvals and certifications obtained by the FS10 instrument.
Specifies safety precautions for using the instrument in various conditions.
Details installation procedures for remote flow elements, especially in hazardous areas.
Outlines safety requirements and precautions during instrument installation.
Provides guidance for installing flow elements in Zone 1, Division 1 hazardous locations.
Illustrates correct sensor mounting orientation for optimal flow detection.
Specifies correct wire gauges for various distances and connections to ensure signal integrity.
Details proper grounding procedures for safety and operational reliability.
Explains requirements and connection procedures for the 24 VDC input power.
Describes the FS10 monitor's functionality as a flow or temperature meter with various output configurations.
Details methods for quickly setting up the device using buttons or PC interface for basic configuration.
Covers standard operation, setting minimum/maximum flow, and adjusting switch points.
Explains configuration of fail-safe, hysteresis, time delay, alarm simulation, and filter settings.
Details the instrument's compliance with FMEDA for safety integrity level (SIL) requirements.
Provides safety identification information, including firmware version requirements for SIS applications.
Outlines specific considerations for installing the FS10 in safety instrumented systems.
Describes a recommended proof test procedure to ensure system safety and reliability.
Provides guidance on routine maintenance for the sensing element and connections.
Offers steps to diagnose and resolve common operational issues with the instrument.
Presents the EU Declaration of Conformity for the FS10 model, listing applicable directives.
Declares the FS10's suitability for use in SIL 2 safety instrumented systems, based on FMEDA.
Illustrates various kits available for connecting the FS10 to a PC for interface and software.
Shows hookup diagrams for the power supply and interface box used with the FS10.
Provides wiring schematics for RS-232 connections to DB9 connectors.
Details wiring pin-outs for M12 connectors used for power, I/O, and remote probe applications.
Outlines how to contact FCI for technical assistance, including phone, fax, and email contacts.
Explains procedures and responsibilities for returning equipment under warranty for repair or replacement.
Informs about the availability of extended warranty options and field service procedures.
To Next Page
General
