Need help?Do you have a question about the FCI ST102A and is the answer not in the manual?
General| Brand | FCI |
|---|---|
| Model | ST102A |
| Category | Measuring Instruments |
| Language | English |
Lists detailed technical specifications for the instrument's performance, ranges, and approvals.
Provides detailed instructions for installing the ST100A Series insertion flow element into process piping.
Details the installation of the STP100A flow element, including process connection options.
Explains the installation of dual-element ST102AA and ST112AA flow elements.
Describes the process connection and mounting of the ST100AL in-line flow element assembly.
Covers the installation of the instrument's electronic transmitter, integral or remote.
Guides users through initial power-up, welcome screen, and basic instrument setup.
Explains the two methods for configuring the instrument: HMI panel or software.
Introduces the PC-based configurator utility for comprehensive instrument setup and programming.
Provides details on using the configuration software and the required user password for parameter changes.
Guides users on configuring the AST™ or Constant Power measurement methods for sensor heater configuration.
Describes the routine for checking the ST100A Series internal normalization using the idR check.
Details HART communication protocol, process data organization, and HART commands.
Explains Modbus communication protocol, setting up for Modbus, and Modbus commands.
Describes how to expand instrument capabilities using Extended Operation Modes like EFI and EGS.
Details how to configure the instrument for External Flow Input (EFI) for flow averaging.
Explains how to configure External Control Group Switching (EGS) for automatic calibration group changes.
Details the procedure for replacing the instrument's input power overload protection fuse.
Provides instructions for replacing the 3-volt lithium coin cell battery that powers the real-time clock.
Details procedures for checking the resistance of the flow element's sensor wires.
Explains how to check the heater parameters (resistance, voltage, current) using the configuration software.
Outlines checks for transmitter power supply, heater, and internal Delta-R resistor status.
Provides troubleshooting steps for instruments configured in Constant Power mode.
Details the Delta R check procedure to verify instrument calibration in Constant Power mode.
Outlines the steps to perform a Delta R check using an FES-200 simulator or decade boxes.
Details safety instructions for using the ST100A Series flow meter in hazardous areas and temperature class relationships.
To Next Page
