To Next PageTo Next Page
Need help?Do you have a question about the FDC FD-150A and is the answer not in the manual?
General| Frequency Range | 150-174 MHz |
|---|---|
| RF Output Power | 5W |
| Output Power | 5 W |
| Modulation | FM |
| Channel Spacing | 25 kHz |
| Channel Capacity | 16 |
Explains icons and symbols used on the LCD screen.
Instructions for attaching the antenna to the transceiver.
How to turn the device on/off and adjust audio volume.
Procedure for sending audio signals using the PTT switch.
Describes the different operational modes available for the radio.
Provides general usage tips and battery information.
Adjusts the squelch level to filter background noise.
Selects the transmission power output (High or Low).
Automatically scans programmed memory channels from lowest to highest.
Manually scans frequencies by increment.
Controls the LCD screen backlight setting.
Enables or disables the keypad beep sound.
Automatically locks the keypad after a period of inactivity.
Limits the duration of a single transmission.
Sets the frequency offset for repeater communication.
Configures CTCSS/DCS codes for receiving signals.
Configures CTCSS/DCS codes for transmitting signals.
Manually locks or unlocks the keypad to prevent accidental presses.
Sets the minimum frequency step increment for tuning.
Selects simplex or duplex operation for communication.
Reverses the transmit and receive frequencies.
Stores current frequency and settings into a memory channel.
Retrieves a stored memory channel for use.
Instructions on how to activate or deactivate Channel Only mode.
Removes a specific memory channel from the device.
Resets all stored settings to factory defaults.
