19
CHANNEL ONLY MODE
Chanel only mode is an operating mode where you ONLY use
pre-programmed frequencies and settings.
a) It works the same as MR mode in VFO/MR mode.
b) It uses only CHANNELS for simplicity of operation and
does not display any frequency information.
c) The CHANNELS are the memory channels programmed
in VFO/MR mode.
d) CHANNELS have to be programmed in VFO mode per
instruction in MEMORY CHANELS above
Entering Chanel Only Mode
To enter, or exit from, Channel Only mode start with the transceiver
off. Press [F] and hold the key while rotating the power switch/volume
control to turn ON.
To Next Page
Loading...
