System Manual
19
Troubleshooting
Please note that the following troubleshooting guide is designed for people with strong computer
hardware knowledge or Engineers and Maintenance.
Touch Panel Does Not Work
A) Check “Touch Display Module” is connected well with terminal.
B) Check HID USB touch device is detected by OS.
C) (Resistive Touch) Check if the EETI driver or the TouchKit driver has been properly
installed. Or try to re-install again (Please refer to the EETI driver and touch kit
installation).
D) (Capacitive Touch) Check if the capacitive touch is automatically detected by Windows 7,
or properly installed the touch driver in Windows XP.
E) Check well cabling between touch panel and touch controller
F) (Capacitive Touch Calibration) Reboot the system, and the Capacitive Touch can be
calibrated automatically.
OSD Panel Cannot Work Precisely
A) Please touch each single OSD button for more than two seconds in order to trigger the
function.
B) Make sure the finger is not touching more than one button each time.
To Previous Page
Loading...