EasyManua.ls Logo

Fedders AEP09D2B - Safety Symbols and Warnings; Important Grounding Requirements; Recommended Wire Sizes; Electrical Shock Hazard Precautions

Fedders AEP09D2B
10 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
RECOGNIZE SAFETY SYMBOLS_
WORDS AND LABELS
Wh_ You Need To Know About
Safety_ Instructions"
.warningandJmportant6afetyinstructionsappearingir
this manual are notmeant to Coverall possible
conditions andsituationsthat mayoccur.Common_:
sense,cautionandcareimust beexerd_edwhen
operatingor cleaningtools,and euuitoment." ..
Always contactyour'deale_distPibut0r;sewice.agem:-or
manufacturer about'pPo_]emSOF:Cond,tionsYoucto::not
understand.,
_1_T_isisthe safety alertsymboLit is used'toalert,you
to potentialpersolial_injuryhazards;Obepall:safe_:
messagesthat follow this symbolto avoidpossible
injury or death.
_L_tK_
DANGERindicatesan imminently hazardoussituation
which,if not avoided,will resultin death orserious
injury.
r A WARNING ". '}
WARNING irfdicatesa potentiallyhazardoussituation"
which,if not avoided,could resultindeath orserious
injury.
l& CAUtiONr I
_ttrlON indicatesan potentiallyhazardous'sltuation.
which,if not avoided,mayresultin minorprmoderate
injury.
I.cAuTIoN t
CAUTION usedwithodt the safety,alektsymbol
indicate_a potentiallyhazardoussituationwhich,if not
avoided,may resultin propertydamage.
Important Grounding Requirements
Air conditionerhasa three-prong grounding plug
on the power supply cord, which mustbe plugged
into a properly grounded three-prong wall
receptacle for your protection against possible
shock.hazard. For models up to and including 7.5
amperes,use a grounding type wall receptacleto
match.the cordplug.
For mode!s above 7.5 amperes use a-single outtet
grounding t_pe wal! receptacle to match the cord
plug,
Do not operate this air conditionerwithout proper
time delay circuitprotection(circuit breaker or fuse),
Refer to serial plate for proper power supply
requirements.
%,
Recommended Wire Sizes
(Asinstalledper building code):
PROTECTORSIZEWIREGAUGE
,15 AMP#!4 MINIMUM _'(_ (_._"
:20"AMP#i_'MINIMUM 125V 250V 250V 250V
30 AMF#;i;_:r_NIMUM _ 15A 20A 15A 30A
Electrical Shock Hazard
Plugunit onlyinto a _'?aundedelectricaloutlet
Db not use an extension'cord or plug adapter with
this unit. Do not alter cord or plug end. Do not
remove warning label on cord.
Dp not operate unit with decorative front or filter
removed.
, tf the air conditioner has a serial plate rating of 115
volts and greater than 7.5. amps, it must have its
own fuse or circuit breaker, and no other device or
.unit should be operated on that fuse or circuit
breaker.
if the air conditionerhas a sedaJ plate rating of 230
volts, it must have its own fuse or circuit breaker,
and no other device or unit should be operated on
that fuse or circuit breaker.
We recommend that a qualified electrician insta[I
unit in accordance with the National Electrical Code
and local codes and ordinances.
Use copper conductors of correct wire gauge and
protector size only,

Related product manuals