- 12 -
6.4.1 Check
Check the waterproof performance before using for the rst time or has not been used
for a long time.
Before placing the device into the waterproof case, mount on the waterproof cover
and completely tighten the securing ring and dip the case into water with a depth of 30
cm for at least 10 mins. lf water seeps in, take it out and check the case.
6.4.2 Installation
(1) Open the waterproof cover: Rotate the securing ring
in the unlock direction until the waterproof cover can
be removed.
(2) Selecting diving mode: Turn on the Feiyu Pocket 3
and press the gimbal mode button four times to enter
the diving mode.
*Diving mode is a working mode which work with
waterproof case.
Disable: Follow mode setting/ Sele mode/ Timelapse/
Panorama/ Remote Handle
(3) Place in the device: Power o the Feiyu Pocket 3 in
diving mode, then slide it into the slot and connect it to
the USB-C plug.
(4) Install waterproof cover:
Put the securing ring on the waterproof cover,
clip in the mount on the handle of waterproof
case, tighten the securing ring.
Shake the waterproof case by hand, check if
there is any clearance which may cause shaking
of the device. If so, please tighten the securing
ring again.
To Next Page
Loading...
