How to fix a Fellowes Jupiter 2 pouch that does not completely seal?
The item you are trying to laminate might be too thick. The maximum document thickness should be .03 inches. Try passing it through your Fellowes Laminator a second time.
Why is there no glowing ‘blue’ Power on LED on my Fellowes Laminator?
The Fellowes Laminator might not be switched on. Make sure to switch it on at the right side and at the wall socket. Also, press the power standby button.
What to do if my Fellowes Jupiter 2 Laminator pouch is lost in the machine?
If the pouch is jammed inside your Fellowes Laminator, press the reverse button and gently pull the pouch out by hand.
Why is my Fellowes Jupiter 2 pouch damaged after lamination?
Damaged rollers or adhesive on the rollers could be the cause. Try passing cleaning sheets through your Fellowes Laminator to test and clean the rollers.
Identifies and describes each control button and indicator for the laminator.
Provides sequential instructions for preparing and operating the laminator for use.
Lists common problems, their possible causes, and suggested solutions for the laminator.
Details how to safely store and clean the laminator for optimal performance.
General| Auto Shut-Off | Yes |
|---|---|
| Jam Prevention | Yes |
| Maximum Pouch Thickness | 5 mil |
| Maximum Laminating Width | 12.5 inches |
| Warm-up Time | 60 seconds |
| Power Consumption | 600W |
| Pouch Sizes Supported | Up to 12.5 inches wide |
| Pouch Thickness | 3-5 mil |
To Next Page