Mustang Micro easily streams Bluetooth audio, so you can play along in your headphones
or earbuds. The device is discoverable as “Mustang Micro” on smart phones and other
Bluetooth devices.
To activate Bluetooth pairing mode, push the POWER SWITCH (G) to the left, where the
Bluetooth symbol is, and hold it there for two seconds. The POWER SWITCH Bluetooth
position is spring-loaded for momentary contact only, and will return to the center “ON”
position when button is released. In pairing mode, the POWER SWITCH LED will ash blue
for two minutes or until a connection is established.
On successful connection, the LED will turn solid blue for 10 seconds and then extinguish.
To disconnect a Bluetooth device from Mustang Micro, hold the POWER SWITCH in the Bluetooth position for two
seconds and then release it (as when pairing). This will end the Bluetooth connection and return Mustang Micro to
pairing mode with a ashing blue LED; pairing mode will expire within two minutes if no other Bluetooth connection
is made, and the blue LED will extinguish. Alternately, disconnect using the external device.
Mustang Micro automatically pairs with the last connected Bluetooth device if that device is available. Note that MAS-
TER VOLUME (B) controls instrument and overall volume only; the mix between an instrument and a Bluetooth audio
source is determined using the volume control on the external Bluetooth device.
BLUETOOTH
Mustang Micro provides up to six hours of battery-powered operation. Recharge Mustang
Micro using the USB-C jack (H) on the bottom of the unit and the included USB cable.
POWER SWITCH (G) LED color indicates charging status:
CHARGING
POWER SWITCH
LED COLOR
BATTERY STATUS
Yellow (Solid)
USB is connected and unit is charging whether
power is on or o.
Green (Solid)
Power is on, USB is connected and battery is
fully charged.
Green (Flashing)
Battery is at greater than 50 percent and USB is not connected. LED ashes
green for one second every ve seconds.
Yellow (Flashing)
Battery is at 20 percent-50 percent and USB is not connected. LED ashes
yellow for one second every ve seconds.
Red (Flashing)
Battery is at less than 20 percent and USB is not connected. LED ashes red
for one second every ve seconds.
Red (Flashing rapidly)
LED ashing red rapidly while unit is on and USB is plugged in indicates a
battery charge error possibly due to extremes of temperature. Unplug USB,
turn unit o, allow unit to reach room temperature, restart unit.
7
To Next Page
Loading...
Need help?
General
