Fender SPL-6000P User Manual

Power Amplifiers
From Fender Pro Audio
Owner's Manual for
SPL-6000
P/N 038866

Fender SPL-6000P Specifications

Power Output

stereo continuous sine wave output power into 8 Ω	150 W each channel
stereo continuous sine wave output power into 4 Ω	300 W each channel
mono bridge output power into 16 Ω	300 W
mono bridge output power into 8 Ω	600 W
single channel driven output power into 8 Ω	179 W
single channel driven output power into 4 Ω	312 W

Frequency and Sound

power bandwidth	10 Hz to 68 kHz
frequency response	+0 -3dB; 5 Hz to 68 kHz
rise time	Less than 5.2 µSec
slew rate	Greater than 13.5 V/µSec
total harmonic distortion	Less than 0.03%

Noise and Impedance

hum and noise broad band	95 dB
hum and noise IEC A Weight	102 dB
damping factor 5 Hz to 20 kHz	Greater than 30
damping factor 1 kHz	Greater than 175
input impedance	33 kΩ

Sensitivity and Separation

channel separation	Greater than 65 dB
sensitivity stereo mode	+1.8 dBV (1.23V)
sensitivity bridged mode	+1.8 dBV

Operating Conditions

cooling	Two speed fan
power requirements	1000W
status indicators	Peak LED (red), Power LED (green)
gain controls	Continuously variable attenuator, one per channel
mode switching	Stereo-Mono Bridge, Stereo-Dual Mono, two push button switches

Weight and Dimensions

weight	11.3 kg
height	8.9 cm
width	48.3 cm
depth	38 cm