THIS MANUAL IS PROVIDED AS AN INSTALLATION, OPERATION AND
MAINTENANCE GUIDE FOR THE EX 200™ SINGLE ZONE CONTROL PANEL. THE
CONTROL PANEL SHOULD NOT BE INSTALLED IN ANY SYSTEM UNLESS THE
SPECIFIC APPLICATION AND SYSTEM DESIGN HAS BEEN REVIEWED AND
APPROVED BY FENWAL.
FENWAL RECOMMENDS THAT ONLY AUTHORIZED PERSONNEL INSTALL,
SERVICE AND MAINTENANCE THE SYSTEM. THIS ENTIRE MANUAL SHOULD BE
REVIEWED BEFORE INSTALLATION IS STARTED.
IF PROBLEMS NOT COVERED IN THIS MANUAL ARISE, OR IF FURTHER
CLARIFICATION OF THE INSTRUCTIONS PRESENTED WITHIN ARE REQUIRED,
CONTACT YOUR LOCAL FENWAL EXPLOSION PROTECTION DISTRIBUTOR OR
THE FENWAL PROTECTION SYSTEMS INDUSTRIAL EXPLOSION PROTECTION
DESIGN OR SERVICE GROUP AT KIDDE-FENWAL, 400 MAIN STREET, ASHLAND,
MASSACHUSETTS, 01721 USA, TELEPHONE: 508-881-2000, FAX 508-485-3115.
To Next Page
Loading...