Page 5 of 17
Rudolf Dieselstraat 15A, Nijverdal, Nederland. +31 523 0613439. Mail: Info@ferlin.nl
Installation:
• Remove the dosing part and main hopper before installation.
• Connect power supply and compressed air only when installation on the right place is
completed.
• The following should be available:
o 110-240V 50/60Hz (P+N+E)
o Clean and dry compressed air with a constant
pressure of minimal 4 and maximum 6 bar.
• When installing the FERLIN ONE directly on the feed throat of the injection, extrusion, blow
moulding or other plastic processing machine, the owner of the FERLIN ONE should
provide a flat and save surface surrounding the FERLIN ONE for performing maintenance.
• It must be ensured that the Ferlin ONE is not subject to collision hazard. If this cannot be
guaranteed, installation on input zone is prohibited.
• The FELIN ONE should be installed with a minimum of 4 bolts class 8.8. All parts should be
aligned and securely tightened.
• After installation of the FELIN ONE the dosing part and main hopper can be put back on the
machine.
• The FERLIN ONE may only be made operational when fully assembled.
• The FELIN ONE needs to be well grounded.
Maintenance:
• All maintenance actions should be executed by well-trained co-workers.
• Electric maintenance is only allowed to be executed by qualified staff.
• While performing maintenance always disconnect the FERLIN ONE from the power supply by
removing the power plug.
• While performing maintenance always disconnect the FERLIN ONE from the compressed air
connection.
• Wear eye protection while performing maintenance on the FERLIN ONE.
• In case of replacement of any of the electronic components inside the control box the co-
worker is obligated to wear a wristband which is well grounded to prevent static electricity.
• In case of maintenance actions which can cause dust to get free, the co-worker should wear
breathing protection.
Cleaning:
• Before cleaning, always disconnect the FERLIN ONE from the power supply by removing the
power plug.
• Before cleaning, always disconnect the FERLINE ONE from the compressed air connection.
• Wear eye protection while cleaning the FERLIN ONE.
• Wear breathing protection while cleaning the FERLIN ONE.
To Next Page
Loading...