Ferm CDM1112S - Warranty; Maintenance

10
EN
• Whendelivered,thebelthook(13)is
assembled to the left side of the machine.
• Itcaneasilyberemovedbyremovingthe
screw on the hook and taking it off.
• Itcanbeassembledontherightsideofthe
machine when this is preferred.
User tips
When driving screws into wood, metal and other
materials:
• Beforeusingtheappliancecheckifthedrillor
screw bit is properly fitted and centered inside
the drill chuck.
• Screwbitsareavailableinseveralshapesand
dimensions. When unsure, always try if the bit
fits on the screw head without any free play
before using the machine.
• Makesurethemachineisnotrunningwhen
it contacts the screw. A rotating bit may slip.
This could result in damage to the work piece.
When drilling into wood, metal and other
materials:
• Withsmalldiameterdrillsuseahighdrill
speed. For large diameter drills use a low drill
speed.
• Forhardmaterials,selectalowdrillspeed,for
soft materials select a high drill speed.
• Fixtheworkpieceproperly,preferablyby
using a clamp or vice.
• Duringdrillingdrawbackthedrilloutofthe
hole frequently so swarf or drill dust will be
removed.
When drilling in metal:
• Useametaldrill(HSS).Forthebestresultsyou
should cool the bit with oil.
• Metal(HSS)drillscanalsobeuseddrillinginto
plastic.
4. MAINTENANCE
Before cleaning and maintenance, always
switch off the machine and remove the
battery pack from the machine.
Clean the machine casings regularly with a soft
cloth, preferably after each use. Make sure that
the ventilation openings are free of dust and
dirt.Removeverypersistentdirtusingasoft
cloth moistened with soapsuds. Do not use any
solvents such as gasoline, alcohol, ammonia,
etc. Chemicals such as these will damage the
synthetic components.
WARRANTY
The warranty conditions can be found on the
separately enclosed warranty card.
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected
at the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic
waste. According to the EUropean Guideline
2012/19/EU for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable must
be collected separately and disposed of in an
environmentally friendly way.
The product and the user manual are subject
to change. Specifications can be changed
without further notice.