Ferm CDM1112S - Technical specifications; OPERATING; Removing the battery from the machine

7
EN
Technical specifications
Model No CDM1112S
Charger CDA1079S
Input of charger
100-240V~ 50/60Hz
Max.1A
Output of charger 12.6V DC 2A
Rechargeable battery pack 10,8 V
Li-ion 1.3Ah
Battery charging time 45 minutes
Chuck capacity 0.8 - 10 mm
Torque settings 20 + Drill mode
No load speed
Position 1:
Position 2:
0-350 /min
0-1200 /min
Weight (incl. battery) 1,02 kg
Sound pressure level L
PA
65.17 dB(A), K=3dB(A)
Sound power level L
WA
76.17 dB(A), K=3dB(A)
Hand-arm vibration a
h
(screwdriving without impact)
0.846 m/s
2
K=1.5 m/s
2
Hand-arm vibration a
h,D
(Drilling into metal)
1.739 m/s
2
K=1.5 m/s
2
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardized test given in
EN60745; it may be used to compare one tool
with another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned.
• Usingthetoolfordifferentapplications,orwith
different or poorly maintained accessories,
may significantly increase the exposure level.
• Thetimeswhenthetoolisswitchedoffor
when it is running but not actually doing the
job, may significantly reduce the exposure
level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns.
Description
The numbers in the text refer to the diagrams on
pages 2- 4
Fig. A
1. Machine
2. Battery
3. Battery unlock button
4. Battery charge indication
5. Charger
6. Charger LED indicator
7. Chuck
8. Gear selection switch
9. Direction switch
10. On / off switch
11. Torque adjustment ring
12. Work light
13. Belt hook
Lithium-Ion technology
The batteries provided with this machine have
Lithium-Ion technology.
One advantage of using Lithium-Ion
batteries is that, until the battery is almost
empty, hardly and power fading is
noticeable. The machine can be used
until you start noticing that the power of
the drill is elapsed. The battery is
discharged now and needs to be
charged.
Another advantage is that Lithium-Ion
batteries have no memory effect.
Therefore they can be charged at any
moment without degrading, independent
of the charging state of the battery.
3. OPERATING
The battery must be charged before first
use.
Removing the battery from the machine
Fig. B
• Holdthemachine(1)firmlywithonehand
• Pushthebatteryunlockbuttons(3)locatedon
theleftandrightsideofthebattery(2)andpull
the battery out of the machine like shown in
Fig. B.