Fermax MEET MILO DIGITAL PANEL - Page 25

25
The screen will display
information
about panel settings:
• Firmware version
• GENERAL settings
• Serial number
• IP address
• MAC
GUEST CODE
This function allows users open the door by means of entering a numerical code that has been given
to him, for example to get access during a certain day.
The panel shall have installed a GUEST CODE MODULE Ref.1494 and a third-party Access Control
System is required.
Dial “A7” to enter in GUEST CODE mode:
ON SCREEN INFORMATION
It is possible to get basic information on the equipment configuration through the screen
Dial “9999” followed by “bell” button.
Users shall enter the correct GUESS
CODE followed by “bell” button.
To cancel, just dial “A”
If the CODE is correct, the door will
open
INVALID CODE
The entered code is not valid.