Page 15
SMILE VDSSMILE VDS
SMILE VDSSMILE VDS
SMILE VDS
SMILE VDSSMILE VDS
SMILE VDSSMILE VDS
SMILE VDS
4. The selected option is displayed on the white line under the icon. Press , and a screen
appears confirming the selected option: programming from the panel and you hear a
beep on the monitor.
_ _ _
_ _ _
2222
4444
1
5. The monitor automatically connects to the street panel, activating the camera (this
shows a panel icon in the upper left corner of the monitor). Enter the calling code for this
monitor from the panel. Depending on the type of panel installed:
- pressing the corresponding button or
- by entering the code + bell.
Notes:
- The time between steps 4 and 5 must be less than 2 and half minutes.
- Programming is always done from the panel activated as the main panel.
A different calling tone is produced, confirming the monitor´s programming, continuing
to view the camera´s image and
after a few seconds the monitor returns to the
programming screen.
4444
Panel
icon
0 2 8
_ _ _
2222
4444
1
To Next Page
Loading...
Need help?
General
