Ferno 30-NM - Safety and Instruction Labels; MR Conditional Testing and Compliance

© Ferno-Washington, Inc. / 234-3298-02 / May 2018
5
1.7 MR Conditional Testing
and Compliance
This Ferno® Model 30-NM cot has been tested and is listed as “MR
Conditional.”
A product that is Magnetic-Resonance Conditional (called MR
Conditional in this manual and on product labeling) has been shown to
pose no hazards in a specied MR environment under listed conditions.
LISTED CONDITIONS OF USE
The Ferno® Model 30-NM Cot has undergone testing and has been
determined to be MR Conditional. In general, the cot is intended for use
under the conditions listed here:
● Static magnetic eld of 3-Tesla
● Spatial gradient magnetic eld of 720-Gauss/cm or less
● Inside the MR environment (e.g., in the MR system room, close to
the scanner)
The cot is not designed or designated for use directly inside the MR
system (e.g., inside the bore of the scanner).
FERNO COMPLIANCE
Ferno adheres to the ASTM International classication and denitions
found in the following document:
The American Society for Testing and Materials (ASTM)
International, Designation: F2503-05: “Standard Practice for
Marking Medical Devices and Other Items for Safety in the
Magnetic Resonance Environments” [Published August, 2005]
Non-clinical magnetic eld interaction testing has been conducted by
an independent, third-party testing service.
1.6 Safety and Instruction Labels
Safety and instruction labels place important information from the
users’ manual on the cot. Read and follow label instructions. Replace
worn or damaged labels immediately.
Safety Information
Identication label
Pinch Point Label (4)
MR Conditional Label
ASTM Contact Information
ASTM International
100 Barr Harbor Drive, P.O. Box C700
West Conshohocken, PA 19428-2959, USA
Internet: https://www.astm.org/
MR Conditional
3-Tesla, 720-Gauss/cm