Ferno 30-NM - General Specifications; Components

© Ferno-Washington, Inc. / 234-3298-02 / May 2018
9
3.2 General Specications
Specications for the cot are shown in the tables at right. General
specications are rounded. Metric conversions are calculated before
rounding the Imperial measurement.
Ferno reserves the right to change specications without notice. For
more information, contact Ferno Customer Relations or your Ferno
distributor (page 2).
● Height measurements are from the ground to the patient surface,
measured at the casting in the center of the bed surface.
● Weight is without mattress, patient restraints and optional features.
● All Ferno® mattresses for emergency medical service use are fully-
sealed.
Specications Imperial Metric
Load Capacity 400 lb 181 kg
Load Capacity (UK) 28.5 st
Weight 54 lb 24.5 kg
Cot Construction Tubular aluminum
Wheel Bearings Sealed/greaseless
Dimensions Imperial Metric
Height
Maximum 32-3/4 in 830 mm
Folded Height 12-1/2 in 320 mm
Width
Overall 24 in 610 mm
Length
Maximum 78 in 1980 mm
Minimum 63-3/8 in 1610 mm
Wheels (Diameter x Width) 5x1-1/2 in 127x38 mm
3.3 Components
Sidearm (2)
Side Control Handle
Control-End Control Handle
Transport Wheel
with Wheel Lock (4)
Backrest
Lead Handle
Footrest
Telescoping Frame
Main Frame
Undercarriage
About the Cot
Load Capacity
Inspect the cot if the load capacity has
been exceeded. See “Inspecting the Cot”
on page 18.
400 lb
181 kg
28.5 st