© Ferno-Washington, Inc. / 234-3298-02 / May 2018
6
2 OPERATOR FOCUS
2.1 Operator Training
Operator using the cot:
● must read and understand this manual.
● must have training on proper use of the cot.
● must have training on emergency-medical service and emergency
patient-handling procedures.
● must have the physical ability to assist the patient.
● must practice with the cot before using it with a patient.
● must keep training records. For a sample training record sheet, see
“Training Record” on page 22.
Training Videos: Ferno cares about operator and patient safety. For
training videos on the operation of the cot, visit our training website
listed below, or scan the QR code on this page.
https://www.youtube.com/user/fernoems
2.2 Operator Height and Strength
The operators must lift and hold the combined weight of the cot, patient
and equipment into and out of the ambulance.
Use additional help as needed to lift the weight of the cot, patient and
equipment. See “Using Additional Help” on page 7.
Operator Focus
WARNING
Untrained operators can cause injury or be injured.
Permit only trained personnel to operate the cot.
Training
Scan the QR Code below with an internet-
connected device to visit the Ferno training
site.
2.3 Daily Operator Duties
It is good practice for operators to check equipment at the start of each
work shift. To check the cot prior to use, follow the procedures described
in this manual:
● Unload the cot from the ambulance.
● Fold the cot to the oor or ground.
● Raise the cot to a suitable rolling height.
● Visually inspect the cot for readiness. See “Inspecting the Cot” on
page 18.
● Rotate the cot in a circle to verify it rolls easily.
● Load the cot into ambulance and secure it in the fastening system.
If inspection shows damage or excessive wear, remove the cot from
service until repair is made. See “Parts and Service” on page 20.
To Next Page
Loading...
