FERREX CSP50 - Chain Lubrication Check and Adjustment; Checking the Chain Brake

26
Symbole
• Release the chain brake by pulling the front hand guard (1) backwards (see g. D). CAUTION!
The chain brake is now released. If the throttle (10) is actuated together with the throttle inter-
lock (9), the saw chain (17) starts up.
9.1.2 Starting the engine when warm
(The device stood still for less than 15–20 minutes)
m WARNING
Engage the chain brake before every start-up (push the hand guard (1) forward).
• Push the front hand guard (1) forwards until it latches into place. The saw chain (17) is
clamped by the chain brake.
• Switch the ON/OFF switch (6) to “ON”.
• The cold start lever (choke) (8) does not have to be pulled to start a warm engine.
• Place the tip of your shoe in the rear hand guard (12) (see g. C).
• Hold the chainsaw rmly by the front handle (2) and pull the start pull cord (4) out slowly
until you feel the rst resistance.
• Now pull the start pull cord (4) quickly. The device should start after 1–2 pulls. If the de-
vice has still not started after 6 pulls, repeat the procedure described under “Starting the
engine when cold”.
9.2 Shutting the engine o
9.2.1 Emergency stop procedure
If it is necessary to stop the device immediately, set the ON/OFF switch (6) to “OFF”.
9.2.2 Normal stop sequence
• Release the throttle (10). The engine goes into idle speed.
• Then set the ON/OFF switch (6) to “OFF”.
9.3 Operating while idle
m ATTENTION
When idling, the saw chain (17) must be stationary. If the saw chain (17) moves, adjust the
idle speed!
NOTE
If the saw chain (17) moves at idle or the engine stops on its own when the throttle is re-
leased, a carburettor adjustment must be made (see chapter “Maintenance of the carburet-
tor settings”).
Commissioning